Bion Experiment "B3"- Testing the 3-Dial Bion-Flow Analyzer Device (3DBFAD)

ABOVE:(3DBFAD Device Developed at Laboratory 5 tested, tried, and verified. It looks similar to many 3 dial radionics devices but in this case : it really is what's inside that counts

using an integrated Archemyte Core with Bion-kinetic potential difference measurement)

Wrapping up the first phase of our research and development project on getting an idea of how to locate, catalog, and understand some fundamentals of the Bion vesicle we came out with a tremendous amount of understanding. It aided us in the design of a new type of Radiorgonomic Device that utilized bions as a power source as well as a critical ability to fully realize how we might measure and analyze samples utilizing their bions as a rate of measurement. From our very first blog post we introduced our researched (and now evaluated method of acquiring rates)

We created a comprehensive test to either prove or disprove the 3DBFAD today utilizing a number of samples in controlled conditions performing pH tests to verify that each sample was not only real but of the same type and the location verified by photograph. On top of this each sample was tested three times Here follow the results of our calculations, observations, and measurements.

SAMPLE A

23 Witty Avenue, Ingersoll, ON

(50 mL of sample collected)

front yard

ABOVE: where the sample was removed

verified independent sample

RATE ACQUISITION FOR SAMPLE A

test 1 - rate: 563

test 2 - rate:554

test 3 -rate:554

Our pH control sample in the ideal range of water (we used distill water to calibrate our tests as is the usual protocol).

above: 7.8-8.4 pH on litmus paper for Sample A

Here is our secondary verification test litmus strips

7.6-7.8pH from front lawn sample

SAMPLE B

Atlantic Packaging (exact address witheld)

(at lot corner near Dean Crescent)

50 mL of sample collected

(verification of location of sample)

(below verification of removed sample)

(below verification of independent sample)

RATES FOR SAMPLE B

Test 1 -Rate- 456

Test 2-Rate-457

Test 3-Rate-446

For our pH Control Sample and Comparison Chart for the litmus tests performed please refer to the data previously recorded in Sample A. Here follows the data for sample B.

8.2 pH for sample B

Performed a control verification and received 8.2 pH again.

below:litmus test for sample B: 7.8-8.4 pH

SAMPLE C

Atlantic Packaging (address witheld)

Rear of location.

50 mL of sample collected

(location of sample verification)

(sample C removed)

(physical specimen collected)

Rates for Sample C

Test 1-Rate-456

Test 2-Rate-445

Test 3-Rate-456

above: sample c- 8.2 pH

above: (sample c litmus: 7.8pH-8.4pH)

SAMPLE D

23 Witty Avenue, Ingersoll, ON

Rear of location

50 mL of sample collected

below: location verification

below sample D removed from site

sample d collection verification below

Sample D Rates

Test 1-Rate-445

Test 2-Rate-444

Test 3-Rate-455

(litmus test for sample D : 7.8-8.2 pH)

above: (sample D: 7.8-8.4pH)

CONCLUSIONS

Other than the fact that I need to perhaps add a bit of lye to my soil lol

The measurements I took with the 3DBFAD takes very accurate and precise readings. I have seen a lot of practitioners taking radionic readings and I do have to say that the lack of transparency in their measurements is astounding. Not to mention the complete lack of an explanation of what it is they are in fact measuring. I have not only done the research to determine what and how the device measures Bions/eloptic energy but I have tested multiple times on this device and have achieved a high precision analytical result.