The Discovery of Radiorgonomy Part 3: Rates , what are they? what do they mean?

Put simply Rates are a measure of the Eloptic energy in a given sample based on the 3 dimensions of that sample's physical construction and form a basis for the analysis of density and motility of Bions.

Eloptic energy was gone over a bit in our last post however, it needs to be clarified that we are not referring to the conventional definition of Eloptic energy as it is typically called: Etheric Energy. In our studies Eloptic energy is the measure of motility and density as a function of power expressed as a graphical "rate" . We need to remove the non-scientific and non valuable pieces of data from our equation therefore in order to maintain objectivity we must dispense with terms like Chi, Prana, Ka and many others and instead examine the relationship Bions have with Bio-magnetism.

(That is not to say to take these words and dispense with them completely that is to say that we endear these terms but to understand them objectively we must adequately provide a point of reference that is not detrimental to measurable judgement).

To measure something we need to ascertain first the quantity (in this case the density, or how many) and it's ability to do work (motility: i.e. movement). Motility as we are speaking in terms of bions refers to the potential to perform work as part of the cell. If a cell cannot perform work it therefore cannot reproduce or survive. On a radionic box proper you will see three dials that have some form of measurement ranging from 0-9.

This single rate dial box would have to be tuned three separate times to achieve the work that would be done tuning one box with 3 dials -- this is just not efficient! (here you can see the calibration dial has tuning Rates from 0-9).

But what does this actually mean?

Many have stated that this refers to frequency and vibration but given that these are radial potentiometers with typical electrical resistance of 1K (ohms) this hardly corresponds with frequency but has more to do with electrical capacitance (more on this later). As for frequency let's examine the following medical study:

(circ.ahajournals.org>200.full.pdf)

(Paul D. Stein, M.D. Hani N. Sabbah, B.S., Jeffrey B. Lakier, M.D., Donald J. Magilligan, Jr., M.D., and Sidney Goldstein, M.D.)

To paraphrase: this was a study to analyze the very first heart beat frequency of babies in the womb. The tests determined through multiple tests that the human heart rate in-vitro was approximately 42 Hz (+/-) 2Hz. If we look at our Scale and we were to measure the frequency of say the human heart our scale would be hopelessly inadequate. Since vibration and frequency are nearly the same thing I see no need to clarify this point any further I will conclude by saying that Rates as they have previously been understood are hopelessly flawed by their inadequacy to explain just what they're trying to express!

(quite literally from my research notes before your very eyes)

The scale above was devised and through all examinations to date has revealed itself to be of invaluable use in correlating data between the variables of motility and density of bions in a sample.

The scale also forms the basis for a standardized control method of observation and analysis and leaves no room for interpolation beyond the objective measurements obtained. In other words: it works it can be repeatedly observed and measured.

Evidently this means a lot of new work on re-acquiring new rates and standards for comparisons must be obtained via this new understanding

More accurate readings mean a clearer definition of formerly misunderstood phenomenon that were previously thought of as too subjective to be concise standards and methods of measurement.

Which brings me to the next point...

"What is 'the stick' in Radionics"?

A stick occurs when the finger of the hand not operating the calibration dials on a radionic machine achieve an actual rate. This is generally accomplished by turning the dials one-by-one and moving the opposite hand's index finger on the "stick" plate until the finger actually stops moving and "sticks" in place .

My issue with this method is once again of subjectivity in a process that is supposed to be objective!

This method can and does vary from person to person not because of the Heisenberg Principle but because it is a motor response-based reading. One person will achieve a rate of 341 and using the same sample(s) and/or methods the next person will acquire a rate of 242--- THIS IS THE REASON RADIONICS IS CALLED PSEUDOSCIENCE!

In the design of a my new analyzer box I've taken this into extremely grave consideration. Since bio-magnetism and motor response are so closely tied together I've devised this solution.

CALIBRATION METHOD FOR ARCHEMYST GRADE RADIORGONOMIC ANALYZER DEVICE

I have a neo-dymium magnetic bracelet that is measured at 50 G . I repeat the measurement 3 times to verify my findings that the magnetism of the bracelet is indeed 50G. I wear this bracelet 2-3 hours prior to analysis . This process serves as a calibration against my own innate bio-magnetic field by normalizing my bio-magnetic field in response to the externally applied field of the bracelet. The stick plate on my device functions as a result of Bion-Bio-Magnetic Resonance and electrical capacitance.

The hand operating the dial will have the same amount of bio-magnetism as the finger on the stick plate therefore negating the contamination factor of my own bio-magnetic field. The stick plate itself is a synthesis of bion reactor and electrical capacitor... essentially an orgone generator but with a very significant twist: it doesn't emit energy from any other source but from the energy delivered to it from the sample in the sample well! A low voltage electrical source acts as a carrier for the bion energy from the sample well and through the dials and stick plate a rate is acquired that is not subjected to the operator's own bio-magnetic resonance. Rather than a "stick" it would be more accurate to refer to the reaction as a "gap" that occurs when the bion flow in the circuit reaches the correct rate of attenuation in relation to the sample on the witness plate and achieves energetic harmonic resonance or simply put balance of charges. The low voltage in the circuit stimulates the bions in the matrix material to flow through the circuit and electrons follow the left-hand rule . Rates are then a graphical representation of bion flow in a given sample as illustrated below:

and rates such as 242 would appear thus:

the above graph represents the amount of bions measured in 1 cm sq of sample on a three dimensional scale.

Taking this new information into consideration combined with the chart displayed earlier would not only give a comprehensive but valid system of measurement of radionic rates obtained from a sample with real results that can be authentically interpreted instead of subjectively measured.